Bedder Covers
  • How to Use
  • Testimonials
  • Blog
  • About Us
  • Contact
    • Inquiries
    • Wholesale
  • SHOP NOW
  • How to Use
  • Testimonials
  • Blog
  • About Us
  • Contact
    • Inquiries
    • Wholesale
  • SHOP NOW

How to install a Bedder Cover

8/1/2016

Comments

 
Bedder Covers come on a 2 inch roll like wrapping paper. It is an adhesive film that works like plastic wrap for those left overs. But this stuff sticks to the sides of your truck and stays put at 80 mph! There is enough material on each roll to cover just about any size truck with any size load.

The easiest way to install is with two people! It is possible with just one person, especially on a smaller truck or small load, but on a big truck things can get tricky. I like to roll out as much as we'll need to cover side, lift it up and over the load, stick the Bedder Cover onto the side of the truck, then cut it with a safety slitter (so I don't accidentally get the paint). 

It is as easy as "unroll, cut, repeat" and just keep going until the load is covered! Make sure you leave overlap on the seams so they don't come apart. Keep in mind you want the wind flowing over the top of the seams so start from the back and move forward. ​
We came up with "wedgies" to wedge in between the cab and the bed. These keep the Bedder Cover from lifting up and getting air underneath. Put as much Bedder Cover in that crack between your cab and bed to hold it down. Then wedge a wedgie in there to hold it in place.
Picture
Comments
Picture

SHOP

Our Online Store
Amazon
Store Locations

USEFUL LINKS

How to use Bedder Covers
Our Story
Privacy
Terms

CONTACT

Wholesale
Questions & Comments

Copyright 2021. All rights reserved